Power Steering Reservoir - Angled
Models This Product Fits
- M3 E92
- M5 E39
- M5 E60
- M6 E63
- M6 Conv. E64
|Description||Billet Power Steering Reservoir - Angled|
These instructions are for experienced technicians only. This job should only be done by an experienced technician. If instructions are need to remove stock components refer to All Data, Mitchel or Factory Manual.
STEP 1: Remove
To reduce oil spilled during replacement, empty reservoir with suction device. If necessary, remove surrounding components (ex: air filter housing) to gain access to power steering hoses. Loosen clamping bolt on bracket. Remove clamps from hoses (If hose clamp is crimp type, cut with pliers) and remove reservoir.
Check condition of hoses. If cracking or swelling, replace hoses.
Installing reservoir: Fit hoses on reservoir. NOTE: supply and return hoses are different sizes. CAUTION: DO NOT OVER TIGHTEN CLAMPS. Slide reservoir into bracket and tighten clamping bolt. Fill reservoir with factory fluid to proper level. Start engine and let run for 1 minute. Shut engine off and let sit for 2-3 minutes. Recheck fluid level.
STEP 4: Vent Kit
Push nipple into vent hole in cap. Route the vent house to a low point in the engine compartment. Make sure the hose is away from belts and hot components in the engine compartment. Secure vent hose with zip ties. Do not over tighten zip ties causing the vent tube t be restricted.
What is the fluid capacity of the AGA Billet Power Steering Reservoir?
BMW’s power steering reservoir has a fluid capacity of 320 Ml. Our Power Steering Reservoirs has a fluid capacity of 604 Ml.
What is the average installation time?
It takes approximately 1-2 hours to install the AGA power steering reservoir. Less than an hour for rear lift.