Start by fishing the AUX connecter out of hole it has fallen into. Align with a pick
on the inside and use a screw driver from down below.
Once the connecter is out make sure the wires don’t fall back into the hole. Carefully push
on the plastic tabs and disconnect the two connectors to the AUX-USB power.
To install the AUX-USB Plug Saver slide it over the housing of the connector, until it clicks
NOTE: Push metal frame over the metal tabs at the same time to avoid bending the
USB-AUX Plug Saver.
Connect the USB power then connect the AUX connector back to the back of the switch. Push
the wires in and push the switch back down.
NOTE: If area where metal tabs make contact is damaged, it may be necessary to clean up
center console with exacto knife or similar. Carefully bending the metal tabs outward on
USB-AUX Connector to increase tension may also be needed.